Whale Plate Diaphragm & Pivot Mk 5 Single Action

$75.90

Whale Plate, Diaphragm & Pivot — MK5 (Single Action). The wet-end service parts for the Whale MK5 single-action manual pump.

Genuine Whale (Navico). Supplied by Y3 Marine.

Add to Quote
SKU: 131246-BLA Category:

Description

This genuine Whale set renews the plate, diaphragm and pivot of the MK5 single-action manual pump — the moving parts that wear and lose output. Fitting them restores full stroke and flow.

Dealer notes

  • For the MK5 single-action pump; confirm single- vs double-action before ordering.
  • Renew the valves at the same time for a complete wet-end refresh.

Fitting & service guide — diaphragm pump wet end

General guidance for servicing a Whale manual/diaphragm pump wet end. Always follow the pump’s own Whale service manual for the exact parts, orientation and torque for your model.

1. Make it safe

  • Isolate the pump. Switch off and remove the fuse (electric), or remove the handle (manual), so it cannot be operated while your hands are in it.
  • Isolate the line. Close the relevant seacock/valve and relieve pressure; have a bucket and rags for residual water.
  • PPE for the duty. For black- or grey-water pumps wear gloves and eye protection, ventilate, and have disinfectant to hand. For an oily bilge, avoid skin contact and dispose of waste responsibly — never pump oily water over the side (MARPOL).

2. Strip the wet end

  1. Record orientation as you go — a quick photo at each step. Diaphragm pumps reassemble only one way.
  2. Release the clamp ring / clamp plate and lift off the cover (upper housing).
  3. Lift out the diaphragm; note which way the dome faces.
  4. Remove the valves (or valve plates). Note the flap/duckbill direction — inlet and outlet face opposite ways; a single reversed valve will stop the pump dead.

3. Inspect & renew

  • Renew both valves together (inlet + outlet) even if only one looks worn — they age as a set, and a half-service soon fails again.
  • Renew the diaphragm if it is stiff, swollen, split or distorted — a tired diaphragm is the usual cause of lost output or prime.
  • Clean the seats and body, clearing scale and debris. A light smear of silicone grease on the rubber-to-plastic sealing faces (never on the valve sealing surfaces) eases assembly.

4. Reassemble & test

  1. Refit the valves the correct way round (flow direction), then the diaphragm (dome as noted).
  2. Seat the cover and tighten the clamp ring/plate evenly in a diagonal sequence — even clamping is what seals it; do not overtighten plastic.
  3. Reconnect the hoses, open the seacock, and re-power or refit the handle.
  4. Test: confirm it pulls prime, delivers full flow, and holds (no back-leak when stopped). Check for weeps around the cover and ports.

Engineer’s notes

  • Service the whole wet end together — valves and diaphragm. The small extra cost of the full service kit saves a second strip-down.
  • Match the material to the duty — Neoprene for general fresh/salt water; Nitrile where oil or fuel is present (oily bilges, diesel).
  • If flow is still weak after a wet-end service, check the suction line for air leaks and the strainer for blockage before suspecting the pump.

Genuine Whale (Navico). Supplied by Y3 Marine.

Additional information

Brand

Whale (Navico)