Description
The FCI Low Pressure Pump Seal Kit (SKU 43-7205) is the genuine OEM seal replacement kit for the low pressure feed pump on FCI Aquamiser and Aquamiser+ watermakers fitted with the 6-bolt Noryl pump head. The low pressure pump is the centrifugal self-priming unit that draws seawater from the sea strainer and feeds it to the high-pressure pump at the correct pressure and flow rate — a seeping or weeping pump seal is an early failure indicator that should not be ignored, as a worsening leak will cause the system to shut down on low feed pressure. FCI recommends replacing the seal kit every 1,000 operating hours or at the first sign of a leak, whichever comes first. Stocked at Y3 Marine for immediate despatch.
Key Features
- Genuine FCI OEM seal kit — SKU 43-7205, correct specification for the 6-bolt Noryl low pressure pump on Aquamiser and Aquamiser+ watermakers
- Noryl pump body (glass-filled PPE/PS engineering plastic) — corrosion-resistant and suitable for continuous seawater service
- 6-bolt pump head configuration — confirm your pump head bolt count before ordering
- Service interval: replace every 1,000 operating hours or when a leak first develops — do not run through a weeping seal
- Leaking LP pump seal is a common cause of low feed pressure shutdowns — fit proactively at the 1,000-hour service to avoid unplanned downtime
- Check LP pump for leaks at the 50-hour break-in service and at every subsequent scheduled maintenance
- Stocked by Y3 Marine, Australia’s authorised FCI dealer — available for immediate despatch
Typical Superyacht Applications
- Scheduled low pressure pump seal replacement at the 1,000-hour service interval on Aquamiser and Aquamiser+ watermakers
- Reactive repair following low feed pressure shutdown caused by a leaking pump seal
- Preventive replacement during a haul-out or extended lay-up refit to restore full watermaker reliability
Installation & Compatibility Notes
- Compatible with: FCI Aquamiser and Aquamiser+ (Framed and Modular) — 6-bolt Noryl pump configuration
- Not compatible with MaxQ+, Atlas+, or Neptune+ — different LP pump configurations use different seal kits
- Isolate seawater feed and depressurise system before disassembling pump head
- Refer to the Aquamiser / Aquamiser+ User Manual for full LP pump seal replacement procedure
- Inspect pump impeller and wear ring for damage while the pump head is open; replace if worn








