Johnson Viking Power 32 & Vacuum Diaphragm (Bare)

Genuine bare replacement diaphragm for the SPX Viking Power 32 and Viking Power Vacuum.

Johnson Pump Marine by SPX FLOW. Supplied by Y3 Marine.

Add to Quote
SKU: 01-36053-2 Categories: ,

Description

Genuine bare nitrile diaphragm for the SPX Viking Power 32 and Vacuum — the pump’s main wear part on its own. For a full rebuild with valves, use the service kit (09-47181).

Fitting & service guide — Viking diaphragm pump service

General guidance for servicing a Johnson Viking Power diaphragm pump. Follow the pump’s SPX service manual for exact parts and orientation.

1. Make it safe

  • Isolate the pump (de-power) and the line; relieve pressure and have a bucket and rags ready.
  • PPE for the duty — gloves/eye protection for black- or grey-water pumps; avoid skin contact with oily bilge water and dispose of it responsibly (never over the side — MARPOL).

2. Strip the wet end

  1. Record orientation (photograph each step).
  2. Open the housing and lift out the diaphragm; note the dome direction.
  3. Remove the valves / valve rubbers — note that inlet and outlet face opposite ways; a reversed valve stops the pump dead.

3. Renew & reassemble

  1. Renew the diaphragm and both valves together — they wear as a set. Clean the seats and body.
  2. Refit valves the correct way round, then the diaphragm; seat the housing and tighten fasteners evenly in a diagonal sequence (don’t overtighten plastic).
  3. Reconnect, re-power and test: confirm prime, full flow and no back-leak or weeps.

Where the housing itself is cracked or worn, fit the complete pump housing; otherwise the diaphragm/valve service kit restores a sound pump. If flow is still weak, check the suction for air leaks and the strainer for blockage.

Johnson Pump Marine by SPX FLOW. Supplied by Y3 Marine.