Description
Jabsco Bronze Pump Spares — General Seals, Gaskets & Hardware
General seals, gaskets, a seal kit and fasteners for the Jabsco bronze flexible-impeller pump range — parts shared across several pumps or matched by number rather than by a single model. The water seal and gaskets are the common wear items; match the part number to your pump’s parts list, or send us the pump model and we’ll confirm.
When does it need servicing?
A flexible-impeller pump loses performance as the impeller and seals wear. Service it when you see:
- Reduced or no flow — worn, hardened or split impeller vanes, or a vane sheared off (check downstream for rubber).
- Loss of prime — a tired impeller or a worn wear-plate / cam.
- Weeping at the shaft — a failed water seal.
- It ran dry — even a few seconds dry wrecks a neoprene impeller; renew it.
Servicing a flexible-impeller pump
- Isolate — close the seacock and kill power/belt; relieve pressure.
- Remove the end cover and gasket; note orientation.
- Withdraw the impeller with an impeller puller (never lever on the housing); inspect the cam, wear-plate and shaft seal.
- Renew the impeller, end-cover gasket and any worn seal or cam; smear the new impeller with Jabsco impeller lubricant — never fit it dry.
- Refit the impeller with the vanes trailing the direction of rotation; fit a new gasket and tighten the end cover evenly.
- Test — open the seacock, confirm prime and full flow, and check for weeps.
Never run a flexible-impeller pump dry — it relies on pumped water to lubricate the impeller.
Dealer notes
- Order by part number — these parts span the bronze range; match against your pump’s parts list.
- The water seal and end gaskets are the usual service items; renew the gasket whenever you open the end cover.
- Unsure of fitment? Send the pump model and the old part number and we’ll confirm.





