Jabsco Bronze Pump Spares — 2″ (Size 200)

Price range: $3.91 through $646.00

Jabsco Bronze Pump Spares — 2″ (Size 200): genuine service parts for the 2″ bronze flexible-impeller pump (50200 clutch, 52200 / 52220 pedestal & composite range). Select your part.

Genuine Jabsco. Supplied by Y3 Marine.

Add to Quote
SKU: N/A Category:

Description

Jabsco Bronze Pump Spares — 2″ (Size 200)

Genuine service parts for the Jabsco 2″ (size 200) bronze flexible-impeller pump — the 50200 clutch and 52200 / 52220 pedestal and composite range. These are the high-capacity engine-driven cooling, bilge and transfer pumps; the impeller and seal wear first, with bearings, shaft seal, clutch adaptor, pulleys, gaskets and fasteners available for a full rebuild. Select your part below.

When does it need servicing?

A flexible-impeller pump loses performance as the impeller and seals wear. Service it when you see:

  • Reduced or no flow — worn, hardened or split impeller vanes, or a vane sheared off (check downstream for rubber).
  • Loss of prime — a tired impeller or a worn wear-plate / cam.
  • Weeping at the shaft — a failed water seal.
  • It ran dry — even a few seconds dry wrecks a neoprene impeller; renew it.

Servicing a flexible-impeller pump

  1. Isolate — close the seacock and kill power/belt; relieve pressure.
  2. Remove the end cover and gasket; note orientation.
  3. Withdraw the impeller with an impeller puller (never lever on the housing); inspect the cam, wear-plate and shaft seal.
  4. Renew the impeller, end-cover gasket and any worn seal or cam; smear the new impeller with Jabsco impeller lubricant — never fit it dry.
  5. Refit the impeller with the vanes trailing the direction of rotation; fit a new gasket and tighten the end cover evenly.
  6. Test — open the seacock, confirm prime and full flow, and check for weeps.

Never run a flexible-impeller pump dry — it relies on pumped water to lubricate the impeller.

Dealer notes

  • Order by part number — match it to your pump’s parts list or the old part.
  • The impeller, shaft seal and end gasket are the routine service items; pulleys and clutch adaptors are for driveline repairs.
  • Confirm the pump model with us if unsure — the 2″ range spans clutch, pedestal and composite bodies.

Additional information

Part

Bearing — SP2601-0458, Circlip — Y5026-08, End Gasket — 816-0000, Slinger — X4020-324A, Single-B Pulley — SP2300-0063RA, Twin-A Pulley — SP2300-0061RA, Clutch Adaptor — 52201-0200B, Shaft Seal — 21849/6408-0000, Cam Screw — SP1005-04, End-Cover Screw (Hex) — X3001-180C, Flanged Port — 2in (Composite Pump)

Brand

Jabsco (Xylem)