Jabsco Bronze Pump Spares — 1″ (Size 80)

Price range: $21.00 through $873.00

Jabsco Bronze Pump Spares — 1″ (Size 80): genuine service parts for the 1″ bronze flexible-impeller pump (50080 clutch and 52040 / 52080 pedestal range). Select your part.

Genuine Jabsco. Supplied by Y3 Marine.

Add to Quote
SKU: N/A Category:

Description

Jabsco Bronze Pump Spares — 1″ (Size 80)

Genuine service parts for the Jabsco 1″ (size 80) bronze flexible-impeller pump — the 50080 clutch and 52040 / 52080 pedestal range. These engine-driven and pedestal pumps run seawater-cooling, deckwash and transfer duties; the impeller and seals are the usual wear items, with the shaft, bearing, circlip and slinger available for a full rebuild. Select your part below.

When does it need servicing?

A flexible-impeller pump loses performance as the impeller and seals wear. Service it when you see:

  • Reduced or no flow — worn, hardened or split impeller vanes, or a vane sheared off (check downstream for rubber).
  • Loss of prime — a tired impeller or a worn wear-plate / cam.
  • Weeping at the shaft — a failed water seal.
  • It ran dry — even a few seconds dry wrecks a neoprene impeller; renew it.

Servicing a flexible-impeller pump

  1. Isolate — close the seacock and kill power/belt; relieve pressure.
  2. Remove the end cover and gasket; note orientation.
  3. Withdraw the impeller with an impeller puller (never lever on the housing); inspect the cam, wear-plate and shaft seal.
  4. Renew the impeller, end-cover gasket and any worn seal or cam; smear the new impeller with Jabsco impeller lubricant — never fit it dry.
  5. Refit the impeller with the vanes trailing the direction of rotation; fit a new gasket and tighten the end cover evenly.
  6. Test — open the seacock, confirm prime and full flow, and check for weeps.

Never run a flexible-impeller pump dry — it relies on pumped water to lubricate the impeller.

Dealer notes

  • Order by part number — match it to your pump’s parts list or the number stamped on the old part.
  • The impeller and shaft seal are the usual wear items — renew the end-cover gasket at the same time.
  • Not sure which part fits your pump? Send us the pump model and we’ll confirm.

Additional information

Part

Bearing — SP2600-38, Circlip — SP1700-247, Slinger — 3180-0000, Shaft — 50087-0000

Brand

Jabsco (Xylem)