Pressure Relief Safety Valve — 5 bar (70 psi)

$294.58

Genuine 500 kPa (5 bar) pressure relief valve for Isotemp Slim and Basic marine water heaters. ½" BSP, factory-preset. Critical over-pressure safety item — inspect at every service and never plug or bypass. BLA 135728.

Available on back-order

Add to Quote
SKU: 135728 Categories: ,

Description

📦 Dispatch & Availability: This item is available on back order. Please allow up to 10 business days to dispatch from the date of order.

Genuine Isotherm pressure relief valve for Isotemp Slim and Basic marine water heaters. Factory-preset at 500 kPa (5 bar) with a ½" BSP thread, it protects the hot-water circuit from over-pressure — a critical safety item on any stored-hot-water system.

What the Isotherm pressure relief valve protects against

The valve relieves if pressure in the hot-water circuit climbs past its 500 kPa setting, protecting the tank, fittings and pipework from over-pressure. A stored-hot-water system must never run without a working, correctly-rated relief valve, and the valve must never be plugged or bypassed.

Weeping valve? Check the accumulator first

A relief valve that weeps a little every heating cycle is usually not faulty — it is relieving thermal expansion. As water heats it expands by 2–3%, and that volume must go somewhere. In a pressurised freshwater system the pump’s accumulator normally absorbs it. Two things are essential:

  • Never fit a non-return or isolating valve in the line between the water heater and the accumulator — close that path and the tank becomes sealed, forcing expansion out through the relief valve every cycle.
  • Keep the accumulator healthy — a waterlogged accumulator or wrong air pre-charge cannot absorb expansion and is a common cause of a weeping valve.

If the valve still weeps once the accumulator is confirmed healthy and the line to it is open, the valve itself is due for replacement.

When to replace

Replace the valve if it has lifted and will not reseat, weeps or discharges in normal operation (once thermal expansion is ruled out), or shows corrosion or scaling. Never plug or bypass a relief valve — it is the circuit’s only over-pressure protection.

Installation & discharge

Route the discharge line downhill to a safe, visible drain point, keep it full-size, and fit no valve or restriction in the discharge line. When retro-fitting to an existing system, tee it into the hot-water line with the 15 mm Brass ‘T’ (135730) and Brass Nipple (135734).

⚠ Australian Compliance

Marine water heaters on vessels in Australian waters require a temperature & pressure relief valve certified to AS/NZS 1271. Confirm the correct rating and compliance with your marine surveyor before commissioning.

Additional information

Brand

Reliance (supplied for Isotemp)

Type

Pressure relief valve

Preset Pressure

500 kPa (5 bar / ~72 psi)

Connection

½" BSP

Fits

Isotemp Slim & Basic water heaters

Retro-fit Accessories

15mm Brass 'T' (135730), Brass Nipple (135734)

BLA Code

135728

Australian Standard

AS/NZS 1271