Clark Pump Check Valve Kit — Ventura

$117.41

Genuine Spectra Clark Pump check valve kit for the Ventura 150C and 200T. Replaces all eight check valve assemblies in the Clark Pump — the correct service part when recovery rate is below specification but piston lip seals are not the cause. Lower cost than a full seal kit; should be the first Clark Pump rebuild item checked when flow is borderline.

Add to Quote
SKU: SW-KIT-HP-CVK-VT Categories: , Tags: ,

Description

Clark Pump Check Valve Kit — Ventura — genuine replacement check valves for the energy-recovery pump. Supplied by Y3 Marine.

About the Clark Pump Check Valve Kit — Ventura

The Clark Pump Check Valve Kit for the Ventura contains all eight check valves used in the Clark Pump pressure intensifier. Check valves are the highest-wear internal Clark Pump components, failing before the piston seals in most cases — making this kit the correct first-stage Clark Pump service item when recovery rate falls below specification.

Clark Pump check valve function: The Clark Pump relies on four pairs of check valves (two per cylinder — inlet and outlet) to direct the reciprocating piston strokes into unidirectional high-pressure product flow. A failed check valve causes internal bypassing: high-pressure brine backflows through the valve instead of exiting as product, directly reducing recovery rate while leaving total feed flow largely unchanged. This symptom pattern — production falls, but total flow is normal — is the primary diagnostic indicator for check valve failure vs. piston seal failure.

Diagnosis — check valves vs. piston seals:

  • Check valves suspect: Total feed flow normal (≥1.65 GPM / 6.2 LPM on 150C, ≥1.6 GPM / 6.0 LPM on 200T) but product flow below minimum (5.7 GPH / 21.5 LPH on 150C; 7.7 GPH / 29.1 LPH on 200T) — service check valves first
  • Piston seals suspect: Constant water flow from the test port during operation — fit SW-KIT-HP-S&O-VT seal kit instead
  • Both failed: Low total flow AND low product flow AND test port flow — full rebuild with both kits, or replace with remanufactured unit SW-KIT-HP-7R (150C)

Pre-service safety: Before opening the Clark Pump, open the pressure relief valve ½ turn counterclockwise to vent the high-pressure circuit. Run a 30-minute freshwater flush to clear the membrane and reduce pressure throughout the system before loosening any fittings.

Fits: Spectra Ventura 150C and Ventura 200T (both 7% and 10% Clark Pump configurations). Pair with SW-KIT-HP-S&O-VT (150C / 7%) or SW-KIT-HP-31-VT200 (200T / 10%) for a complete internal overhaul.

Fitment & ordering

The Clark Pump Check Valve Kit — Ventura is a genuine Spectra part, supplied and supported by Y3 Marine for superyachts and commercial vessels. For the complete system see the Spectra Ventura watermaker, or browse our full Spectra Watermakers range. Contact Y3 Marine for fitment, cross-referencing and current stock. Reference: Spectra Watermakers.